Calculation dialog for v16 and earlier

Single analysis / Batch analysis

In calculation dialog for version 16 and earlier there are two main view on list of possible analysis.

Single analysis where it is possible to choose one type of calculation and Batch analysis where it is possible to choose more than one type of calculation and these calculations will be perform behind a row.

Types of calculations

These items define all possible types of calculations, which can be performed on current model.

Linear calculation	Linear calculation Dynamic seismic calculation Karman vibration Dynamic natural vibration calculation
Nonlinear calculation	Nonlinear calculation
Modal analysis	Calculation model for dynamic analysis
Linear stability	Stability combination
Concrete - Code Dependent Deflections (CDD)	Concrete - Code Dependent Deflections (CDD)
Construction stage analysis	Construction stage analysis Linear versus Non-linear construction stages
Nonlinear stage analysis	Nonlinear stage analysis
Nonlinear stability	Nonlinear stability
Test of input data	It is basically preparation of data from model for Linear calculation. It can be something like check if everything is OK before run of calculation. After performing it, new service "2D data viewer" is available in service "Calculation, mesh", where it is possible to check generated loads on members and other parameters of model.
Engineering report regeneration	After analysis it is possible automatically select list of Engineering reports for regeneration.
Save project after analysis	After analysis actual esa file with project will be save as backup to backup folder.

Buttons

Solver setup	Settings for calculation - Solver setup
Mesh setup	Settings for FEM mesh on members - Mesh setup
OK	This button starts calculation.
Cancel	This button closes calculation dialog without calculation.